Manufacturer Code Charts: 121200

The plausibility check for the torque request from control unit Transmission control was not performed.


Possible cause:

- N15/3 (ETC [EGS] control unit)
Affected functions:

- Power generation

-------------------------------------------------

Test 1: CAN bus communication

1. CAN bus communication
Possible cause

- Functional CAN fault
Remedy

- Read fault memory of control unit N15/3 (ETC [EGS] control unit) and rectify faults.
- Check function impairments using actual values or actuations and restore functionality.
- If present, check codings and correct if necessary.
Note

- A functional CAN fault code is set because of an implausible CAN input signal.
End of test