AN77.50-P-1000-01V Retrofit A-Pillar Roof Rack Mounting

AN77.50-P-1000-01V Retrofit A-Pillar Roof Rack Mounting







1. Remove old mounting clips (3) from A-pillar and replace with new clips







2 Relieve tension on clamping strip (4) by turning rotation clips (5) counterclockwise.

Replace rotation clips (5) after loosening, do not reuse.

3 Slide clip (6) in direction of arrow and remove clamping strip (4) from A-pillar paneling (1).







4 Insert new rotation clips (5) and retaining pins (7) in clamping strip (4)

The flat side of the rotation clip (5) should be flush with the edge of the clamping strip (4) (see magnified section).







5 Position clamping strip (4) on recesses (9) in outer A-pillar paneling (1) and slide in until stop (10) arrests







6 Fasten clamping strip (4) in outer A-pillar paneling (1) by turning rotation clips (5) clockwise
7 Slide clip (6) in direction of arrow.