Restraints - SRS Warning Lamp ON

Date: March 31, 2009

Order No.: P-B-91.60/189

Supersedes:

Group: 91

SUBJECT:
Model 230.470/471/472/474/475/476/477/479, as of VIN F136085

Equipped with Weight Sensing System, Code 494 (USA) SRS Warning in Instrument Cluster On

If you receive customer reports in the above model vehicles that there is a SRS warning in the instrument cluster, this may be due to the WSS control unit connection being loose or unplugged. If the seat is set to a very low position, the connector may contact with the cover of the cable duct under the seat. To remedy this condition, follow the instructions below.

1. Remove front passenger seat. Refer to WIS document AR91.10-P-1000R.





2. Install a new cable cover with modified contour (Figure 1).

3. Reconnect the connector.





4. Secure connector with cable tie as shown in Figure 2.

Note:
The position of the cable tie must exactly match the position shown in Figure 2.

5. Check cable tie for tight seating in order to rule out any subsequent twisting.

6. Affix security label (part no. A003 584 56 38).

7. Reinstall seat. Observe the specified tightening sequence.

8. Connect Star Diagnosis system and erase fault memory.

9. Perform initial start-up of WSS system using special tool W211 589 00 32 00!








Special Tools





Parts Information

Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on March 31, 2009. Please refer to Netstar --> Star TekInfo --> Star Time for the most current labor time allowance.





In Case of Warranty, use the table above.