AR00.19-P-0120-01A Remove Contacts From Sensor Laminated Contact Connector

AR00.19-P-0120-01A Remove Contacts From Sensor Laminated Contact Connector
- Sensor-vane-Contact-Stecker Design 97

220 589 04 99 00, New passenger vehicle wiring harness repair kit







000 589 13 99 00, Wiring harness repair kit, basic







220 589 01 99 50, Blade holder with clamping pliers







220 589 01 99 63, SLK 2.8 - 97 blade







Unpin contact pins from the connector

1 Insert blade holder with clamping pliers and SLK 2.8 - 97 blade from front side into contact cavity of connector housing (4).
Both spring shackles on the contact pin (7) are pressed together and, simultaneously, the locking tab (5) of the connector housing (4) is lifted.







2 A slight tug on the corresponding cable will remove the contact pin (7) from the connector housing (4).
2 A slight tug on the corresponding cable will remove the contact pin (7) from the connector housing (4).