AN82.85-P-0001-01TTA Retrofitting Navigation Processor In Trunk

AN82.85-P-0001-01TTA Retrofitting Navigation Processor In Trunk

On vehicles without Trailer hitch (Code 550)

1.1 Undo nut (1) from bracket of rear SAM control unit with fuse and relay module.
2.1 Fit bracket (2) onto stud and fasten in place using nuts (1).







All vehicles
3 Push navigation processor (N41/1) into control unit bracket (4) until the catches can be heard to engage (see arrow and detail).







4 Fit control unit bracket (4) with navigation processor (N41/1) on guides (see arrows) of bracket for rear SAM control unit with fuse and relay module (N10/2).

Shown on model 211.2








5 Connect the navigation processor coupling (12), MOST coupling (8) and GPS navigation processor coupling (9) to the navigation processor (N41/1).

The connectors are coded to prevent misconnection.







6 Push control unit bracket (4) with navigation processor (N41/1) into guide for bracket (2) as far as the stop.
7 Fasten control unit bracket (4) onto bracket (2) using bolt (5).

Shown on model 211.0