GF82.95-P-2000SK TELE AID Switch-On/Switch-Off Characteristics, Function

GF82.95-P-2000SK TELE AID Switch-on/switch-off Characteristics, Function
- with CODE (359) TELE AID emergency call system

Function requirements
Each telematics service must be authorized separately. If a fault is found or the service has not been authorized, an error message appears in the upper multifunction display (A1p13) of the instrument cluster (A1) and in the display of the COMAND operating, display and control unit (A40/3). The system is ready for operation as soon as circuit 30 has been activated.

Self-test
When circuit 15R has been activated, the emergency call system control unit (N123/4) performs a self test (approx. t = 3.5 sec.). If the test is successful, the system is ready for operation.

Terminating an emergency call
The call is normally terminated by the emergency call center.

The emergency call set-up is terminated after the emergency call system control unit (N123/4) has made 5 unsuccessful dialing attempts.