AR77.20-P-3010T Remove/Install Sliding/Pop-Up Roof Motor

AR77.20-P-3010T Remove/Install Sliding/Pop-Up Roof Motor
- with CODE (414) Power glass tilting/sliding roof

Shown On Model 240:

DANGER:
- Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding roof.
- When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

1 Close sliding/pop-up roof
2 Remove overhead control panel control module
3 Remove front roof paneling
4 Unscrew screws (1) from sliding/pop-up roof drive unit (M 12)
- Screw on sliding roof drive Torx: 4 N.m
5 Remove sliding/pop-up roof drive unit (M12)
6 Install in the reverse order
7 Perform teach-in procedure for sliding roof obstruction sensor