[1] Check component G3/2 (O2 sensor upstream of KAT). Part load Fault: Value is above limit.

[1] Check component G3/2 (O2 sensor upstream of KAT). Part load Fault: Value is above limit.

Test 1: Test components G3/2 (O2 sensor upstream of KAT) and G3/1 (O2 sensor downstream TWC) for Control variation.

1. Test components G3/2 (O2 sensor upstream of KAT) and G3/1 (O2 sensor downstream TWC) for Control variation.
Important note

- After replacement of component G3/2 (O2 sensor upstream of KAT), the lambda values must be reset via menu 'Control unit adaptations'.
Communication with ECU required