Restraints - SRS Lamp ON/DTC 9CFE Set

Date: February 1, 2008

Order No.: P-B-91.60/143

Supersedes:

Group: 91

SUBJECT:
Model 204.054/056/081

SRS Light Illuminated / DTC 9CFE

If you receive customer reports in the above model vehicles that the SRS light in the instrument cluster is illuminated and airbag control unit DTC 9CFE (squib for on-board electrical network line pyrofuse has excessively high resistance) is stored, there may be a faulty contact between the pyrofuse and prefuse box.





Note:
Do not replace the prefuse box or the entire wiring harness! A repair kit for the contact (Figure 1) is available as a replacement part.

Repair Procedure

1. Perform Quick Test.

2. Disconnect battery ground line.

3. Check resistance of ignition circuit with component F32f88 (pyrofuse) as described in Star Diagnosis.

4. Gain access to the prefuse box (refer to WIS document AR54.15-P-1330CW, steps 1 through 3); it is not necessary to remove the prefuse box.

5. Disconnect contact of pyrofuse from prefuse box.

6. Disconnect connector for pyrofuse (Figure 1) from vehicle wiring harness. Select a repair point close to the prefuse box.

7. Repair wiring harness in accordance with specified repair method. Refer to WIS document AR00.19-P-0100-09A (repair wiring harness using solder connectors).

Note:
For the repair, use solder connector sleeves, not axial solder connectors!

8. Wrap repair point with fabric tape up to plug connection for pyrofuse.





Parts Information

Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on February 1, 2008. Please refer to Netstar --> Star TekInfo --> Star Time for the most current labor time allowance.





In Case of Warranty, use the table.