Rear Door Window Motor: Service and Repair

AR72.29-P-1880T Remove/Install Power Window Motor In Rear Door

Shown On Left Rear Door:

1 Remove door foil from rear door

NOTE: Only remove door foil until left rear power window motor (M10/5) or right rear power window motor (M10/6) is accessible.

2 Bore out or mill off blind rivet (1) and then remove bracket (2)

CAUTION: Remove rivet residue and chips from door, otherwise there is a risk of rusting.

3 Separate electrical connector (3)
4 Unscrew screws (4).
- Bolt of motor of electric window lifter of rear door:4.5 N.m

5 Use assembly wedge to push off left rear power window motor (M10/5) or right rear power window motor (M10/6) from inner door panel and then remove

See "Special Tools" given below.

NOTE: Installation: Use Isoflex Topas L 32 to coat gears on left rear power window motor (M10/5) or right rear power window motor (M10/6)

6 Install in the reverse order

Special Tools

Rear Door Window Motor: Service and Repair

Shown On Left Rear Door:

Assembly Wedge, P/N # 110 589 03 59 00: