GF40.15-P-0001-05TR Tire Pressure Monitor (TPM), Messages Relevant to Operation
GF40.15-P-0001-05TR Tire pressure monitor (TPM), messages relevant to operation
- 211 as of 1.6.05
- with CODE (475) Tire pressure monitor (Siemens)
- except CODE (494) USA version
- except CODE (498) Japan version
- 211 as of 1.7.05
- with CODE (475) Tire pressure monitor (Siemens)
- with CODE (494) USA version
Messages relevant to operation in the multifunction display (A1p13) of the instrument cluster (A1) indicate to the driver that the air pressure in at least one wheel is changing or has changed. The messages ensue in "yellow" (information messages) or in "red" (warning messages).
The tire pressure monitor warning lamp (A1e66) in the instrument cluster is actuated in parallel with the warning messages ("red").
Messages relevant to operation are stored in the TPM [RDK] control unit (N88) with an event code.
The messages relevant to operation describe a regular operating condition. In the event of complaint there is no reason to exchange system components.
Message relevant to operation (soft warning with yellow display)
Information message
If the air pressure drops for more than 12 minutes (in one wheel or several wheels) by 0.25 bar under specified pressure adjusted by the driver and stored in the TPM [RDK] control unit, this is displayed in the multifunction display without the position being specified.
The due pressure correction is pointed out after the end of the journey (circuit 15 "OFF"). As a result the driver is requested to check the tire inflation pressure in the wheels, to correct the pressure if necessary and then reactivate the TPM system.
This message is self-acknowledging. It disappears after 30 seconds if it is no longer actuated.
Negative feedback of plausibility check after filling detection (soft warning with yellow display)
A plausibility check of pressure values is carried out as follows:
^ All the tire pressures are above the minimum pressure specific to the model series.
^ The difference between the largest and smallest pressure value is a maximum of 1.5 bar.
^ The pressure difference on an axle is a maximum of 0.5 bar between the right and left.
^ The rear axle pressures may only deviate by a maximum of 0.5 bar from the average front axle pressure.
Warning message (hard warning with red display)
A rapid pressure loss (more than 0.2 bar/min) has been detected. The wheel position is not assigned.
The driver is urged to stop the vehicle immediately and to check all the tires for any foreign bodies which may have entered.
In addition the tire pressure monitor warning lamp in the instrument cluster is actuated.
To make the vehicle safe to drive the spare wheel is to be fitted if necessary or TIREFIT tire repair kit used
Replace the corresponding TPM wheel sensor after TIREFIT is used.
Warning message (hard warning with red display)
A rapid pressure loss (more than 0.2 bar/min) has been detected in the wheel (right rear) (shown for a pressure loss in the right rear tire).
In addition the tire pressure monitor warning lamp in the instrument cluster is actuated.
The driver is urged to stop the vehicle immediately and to check the relevant tires for any foreign bodies which may have entered.
To make the vehicle safe to drive the spare wheel is to be fitted if necessary or TIREFIT tire repair kit used
Replace the corresponding TPM wheel sensor after TIREFIT is used.
Warning message (hard warning with red display)
A pressure loss of more than 20% or 0.5 bar has been detected and the wheel position not assigned.
In addition the tire pressure monitor warning lamp in the instrument cluster is actuated.
Replace the corresponding TPM wheel sensor after TIREFIT is used.
The TPM [RDK] control unit has stored the air pressure of the tires, in each case as a specified pressure to be monitored.
A warning message is also displayed with circuit 15 "ON" after correcting the tire inflation pressure in the workshop.
The TPM system must be reactivated.
The TPM system is activated with an increased tire inflation pressure (approx. 3.5 bar) on new vehicles at the plant.
System message (soft warning with yellow display) after preceding warning message
Possible cause:
If a "red" warning message has been output for the previous circuit 15 "ON", then for the following circuit 15 "ON" the "yellow" system message opposite is displayed as long as the TPM system has not been reactivated. In a parallel operation the system activates the tire pressure monitor warning lamp in the instrument cluster.
System error message
Here wheels without TPM wheel sensors have been installed.
System error message
Here the TPM system is switched off due to a serious fault.
The TPM system is faulty.
System error message
Possible cause:
^ over/undervoltage
^ interference transmitters
The tire pressure monitor is temporarily inactive.
System error message
Possible cause:
^ Spare wheel without TPM wheel sensor
^ Battery (TPM wheel sensor) flat
^ Wheel sensor defective
^ Excess temperature (TPM wheel sensor)
Operation feedback after reactivation
The driver has carried out reactivation via the operating menu in the instrument cluster.