Electrical - Harness Routing Around SAM Module Box

Date: October 2007

Order No.: P-B-54.18/189

Supersedes:

Group: 54

SUBJECT:
Model 211.022

with Engine 642.920

Model Year 2007

Proper Routing of Wiring Harness around SAM Module Box





When removing and replacing the box cover of the Driver Signal Acquisition and Actuation Module (SAM) with fuse and relay module (N10/1), located in the engine compartment, please make sure to route wiring harness below the plastic tab on the box cover - 1, Figure 1.

Note:
The wiring harness runs from the module box to the CDI engine control module.

Refer also to DTB P-B-62.00/03(x) - where "X" refers to the latest update - on subject related to the module box.