AR42.45-P-0841T Remove/Install Yaw Rate and Lateral Acceleration Sensor

Remove, Install Yaw Rate And Lateral Acceleration Sensor









1 Remove front seat

NOTE: Right front seat.

2 Remove front edge guard (2) in area of front scuff plate (1)
3 Remove front scuff plate (1)
4 Remove rear edge guard (4) in area of rear scuff plate (3)
5 Remove rear scuff plate (3)
6 Unclip rear footwell ventilation grill (6) (arrow) and remove
7 Remove rear passenger compartment floor covering (7) below B-pillar paneling (8).
8 Lift up rear passenger compartment floor covering (7).
9 Guide out electrical wiring harness (5) from rear floor lining (7)
10 Unscrew nuts (9)
11 Remove yaw rate and lateral acceleration sensor (B24/15)

NOTE:
- Note correct installation position.
- The yaw rate and lateral acceleration sensor (B24/15) is susceptible to shocks.

12 Unplug electrical connector (10)
13 Install in the reverse order