AZ54.65-P-0001-06T Routeing and Connecting Wiring Harness

AZ54.65-P-0001-06T Routeing And Connecting Wiring Harness

Component Identification:

1. Prepare parking assist wiring harness (25) as shown in the diagram and route in the vehicle.







2. Connect parking assist wiring harness (25) to plug position 17 (arrow) in rear SAM/SRB (N10/2) in left side of trunk.
3. Connect parking assist wiring harness (25) to parking assist connector on FFS/rear bumper (X35/28).







4. Route parking assist wiring harness (25) through the left-hand cable duct in the rear wall to the overhead control panel/FFS connector (X25/8) and connect warning element wiring harness (22).
5. Fasten wiring harnesses with cable straps.







6. Route parking assist wiring harness (25) in left-hand cable duct to the area of the left A-pillar.
7. Unclip CAN-B voltage distributor connector (X30/7) from cable duct and unlock.
8. Connect branch-off line from parking assist wiring harness (25) to voltage distributor (X30/7).
9. Lock voltage distributor and clip into cable duct.