Campaign - Adaptive Brake Control Module Replacement
Campaign No. 2007010007, January 2007FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER
TO: ALL MERCEDES-BENZ CENTERS
SUBJECT:
MODEL 211, 219
MODEL YEAR 2007
REPLACE ADAPTIVE BRAKE (ABR) CONTROL MODULE
This Service Campaign has been initiated because DCAG has determined that on affected vehicles (see VIN range on the following page) the sealing gasket of the adaptive brake control module may not be to tolerance. As a result, some of the convenience features of the ABR braking system may not function. Dealers will replace the adaptive brake control module as a precautionary measure.
Please review the Effective Serial Number chart, and if necessary, repair the subject vehicles during the vehicle's next service.
Prior to performing this Service Campaign:
- Please check VMI to insure the vehicle is involved and to determine if the vehicle has been previously repaired.
- Please review the entire Service Campaign bulletin.
Approximately 13 vehicles are affected.
Effective Serial Number Range
NOTE:
Every vehicle in the VIN range may not be included in the campaign. VMI must always be checked before performing campaigns to verify that the campaign is required on a specific vehicle. VMI always overrides the bulletin in reference to a specific vehicle's inclusion in a particular campaign. Please also note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.
Procedure
Note - Prior to starting the procedure ensure to:
- Use DAS version 10/2006 or higher with all associated patches
- Follow the steps exactly as described in DAS
- Connect battery charger
1. Replace Adaptive Brake (ABR) control module; refer to WIS document AR42.45-P-0820TA.
2. Connect Star Diagnosis.
3. Perform Initial startup of new ABR control module.
- Follow the DAS path "Control units/ Chassis/ ABR Adaptive Brake/ Initial startup/ Replacement of control unit N47-5."
NOTE:
If software installation is required, it will take place during this procedure.
4. Disconnect Star Diagnosis.
Special Tools
NOTE:
The above-listed tool is an MBUSA Required Special Tool; it should already be in every dealer's Special Tool inventory.
Parts Information
NOTE:
- Please be aware that only the part number(s) referenced in the Campaign Bulletin is/are approved for use to repair the vehicle. Repairs performed using any other part(s) will not have been performed in accordance with the campaign. Accordingly, warranty claims submitted with reference to an improper part number(s) will be denied.
- The following allowable labor operation should be used when submitting a warranty claim for this repair:
Warranty Information
Operation: Control Unit for Adaptive Brake (ABR), Replace (02-5446)
Battery Charger, Connect (with SDS connected) (02-5058)
Star Diagnosis System (SDS), Connect & Disconnect (02-4762)
Software for Control Unit Adaptive Brake (ABR), Install (with SDS connected) (02-5452)
Fault Memory (with SDS connected), Read Out/Erase (02-5059)