Cabin Temperature Sensor / Switch: Service and Repair

AR83.30-P-8091T Remove/Install Interior Temperature Sensor
- Interior temperature sensor in lower part of instrument panel






1 Remove electronic ignition switch control module

NOTE: Only remove up to the point where the in car temperature sensor (B10/4) is accessible. Do not disconnect any electrical connectors on the EIS control module.

2 Unlock the in-car temperature sensor (B10/4) in the direction of the arrow, disconnect from the holder (1), and remove from the instrument panel lower section (2).

NOTE: Until the electrical connector at the in-car temperature sensor (B10/4) is accessible.

3 Separate electrical connector at the in-car temperature sensor (B10/4)
4 Install in the reverse order.