Campaign - Brake Fluid Reservoir Cap Replacement

FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER

Campaign No. 2008040004, May 2008

TO: ALL MERCEDES-BENZ CENTERS

SUBJECT:
MODELS 211 AND 219, MODEL YEAR 2007

REPLACE BRAKE FLUID RESERVOIR CAP AND COVERING

This Service Campaign has been initiated because DAG has determined that the cap for the brake fluid reservoir indicates DOT4 brake fluid, not DOT4+. The dealer will replace the brake fluid reservoir cap and covering during the next workshop visit.

Prior to performing this Service Campaign:

^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.

^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.

Please note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.

Approximately 35,136 vehicles are affected.

Procedure





1. Loosen fasteners (arrows, Figure 1) then remove covering (A) over brake fluid reservoir.

2. Remove fasteners (arrows, Figure 1) from old covering (A) and insert into mounting holes in new covering.

Note:
Be careful not to break fasteners.





3. Replace brake fluid reservoir cap (arrow, Figure 2).

4. Install new covering (A, Figure 1) over brake fluid reservoir and secure with fasteners (arrows, Figure 1).





Primary Parts Information

Warranty Information

Note:
^ Please be aware that only the part number(s) referenced in the Campaign Bulletin is/are approved for use to repair the vehicle. Repairs performed using any other part(s) will not have been performed in accordance with the campaign. Accordingly, warranty claims submitted with reference to an improper part number(s) will be denied.





^ The allowable labor operation shown above should be used when submitting a warranty claim for this repair.