AR77.20-P-1000T Remove/Install Sliding/Pop-Up Roof Panel

AR77.20-P-1000T Remove/Install Sliding/Pop-Up Roof Panel
- with CODE (414) Power glass tilting/sliding roof

Shown On Model 211.0:

DANGER:
- Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding roof.
- When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

1 Push paneling (1) at sliding/pop-up roof to the rear
2 Open sliding/pop-up roof approx.20 cm
3 Unclip covering (2) in center and on side with assembly wedge (6), remove covering (2) from rubber bellows (4)

See "Special Tools" given below.

NOTE: Installation: Position covering (2) in center and clip on.

4 Move sliding/pop-up roof to pop-up position
5 Detach rubber bellows (4) on both sides at top and bottom and remove

CAUTION: Handle rubber bellows (4) carefully, otherwise it could be damaged.

NOTE: Note correct installation position.

6 Unscrew screws (5) on both sides

NOTE: Installation: Adjust sliding/pop-up roof panel (3).

7 Remove sliding/pop-up roof panel (3)

CAUTION: Handle sliding/pop-up roof panel (3) carefully, otherwise the paintwork could be damaged.

8 Install in the reverse order
9 Perform teach-in procedure for sliding roof obstruction sensor


Special Tools

Assembly Wedge, P/N # 110 589 03 59 00: