AR68.20-P-4800T Remove/Install Floor Covering In Rear

AR68.20-P-4800T Remove/Install Floor Covering In Rear

Illustrated On Left Side Of Vehicle, Model 211.0 With Code (287) Through Loading Feature:

1 Remove front seat

NOTE: Remove driver and passenger seat.

2.1 Remove rear seat cushion
2.2 Remove rear seat cushion pivot bearing
3 Remove stowage box
4 Remove front edge guard (2) from both sides of vehicle in area of front entrance paneling (1).
5 Remove front entrance paneling (1) from both sides of vehicle.
6 Remove rear edge guard (4) from both sides of vehicle in area of rear entrance paneling (3).
7 Remove rear entrance paneling (3) from both sides of vehicle.
8 Unclip load anchor cover (8) from both sides of vehicle, unscrew bolt and remove load anchor (8).
9 Unclip left and right rear footwell air grate (6) (arrow) and remove
10 Unclip clips (10) on center tunnel and lay electric wiring harness down to side.
11 Pull rear floor covering (9) out below left and right B-pillar paneling (7).
12 Move electric wiring harness (5) for driver and passenger seat adjustment out of rear floor covering (9)
13 Remove rear floor covering (9)
14 Install in the reverse order