AR35.10-P-0050-02T Remove, Install Rear Rubber Mount of Rear Axle Center Assembly Suspension

AR35.10-P-0050-02T Remove, install rear rubber mount of rear axle center assembly suspension

Special Tools:

Workshop Equipment:

Repair Materials:

Remove

Component Identification:

1 Measure insertion depth (a) on inner core of rubber mount (62) on rear axle carrier (8) from the front using depth gauge, record the result.

Component Identification:

2 Press rubber mount (62) with sleeve (15) and thrust piece (16) to the front to remove them from the rear axle carrier (8).

Install

Component Identification:

3 Apply lubricant to the entire periphery of the rubber bushing (62) and clean the mounting socket in the rear subframe (8).
4 Position rubber mount (62) in rear subframe (8) from the front and press into rear subframe (8) using thrust piece (16) and sleeve, continuing until you obtain the penetration depth recorded earlier.