AR35.10-P-0040-03R Remove/Install Rear Rubber Mount In Rear Axle Mount

AR35.10-P-0040-03R Remove/install rear rubber mount in rear axle mount
- except CODE (P99) Special model "AMG Black Series" [model 230]

Modification notes:

Special Tools:

Repair materials:

Component Identification:

Removing
Always replace rear rubber bushings (1b) in pairs.

1 Fit thrust piece (01h) on rubber mount (1b).

The bumps of the rubber mount (1b) must be seated in the recesses of the thrust piece (01h).

2 Fit bracket (01i) on rear axle carrier.
3 Pull the rubber bushing (1b) out of the rear axle carrier by screwing in the spindle (01m).

Component Identification:

Install
4 Rub circumference of rubber mount (1b) with liquid lubricant.
5 Fit bracket (01k) on rear axle carrier.
6 Insert rubber mount (1b) into thrust piece (01l).

The bumps of the rubber mount (1b) must be seated in the recesses of the thrust piece (01l). Pay attention to installation position. The notch (arrow) of the rubber bushing (1b) must point towards the vehicle rear.

7 Pull rubber mount (1b) flush into rear axle carrier by screwing in the spindle (01m).