Manufacturer Code Charts: 2805

The signals of the range selector sensor are implausible in comparison to the signals from the electronic selector lever module.


Possible cause:

- Y3/8s1 (Selection range sensor (VGS))
Affected functions:

- Automatic transmission Function

-------------------------------------------------

Test 1: Remedial action after a plausibility error between the signals from components Y3/8s1 (Selection range sensor (VGS)) and N15/5 (Electronic selector lever module control unit)

Test 2: Remedial action after a plausibility error between the signals from components Y3/8s1 (Selection range sensor (VGS)) and N15/5 (Electronic selector lever module control unit)

1. Remedial action after a plausibility error between the signals from components Y3/8s1 (Selection range sensor (VGS)) and N15/5 (Electronic selector lever module control unit)
Operation number of operation texts and work units or standard texts and flat rates:27-0641Cause

- The shift rod is not adjusted correctly.
REMEDY

- Adjust the shift rod as per the repair instructions.
WARNING

- This is not a function error in system 'ETC' and does not justify exchanging components.
- If the complaint occurs repeatedly contact your workshop support.
End of test

2. Remedial action after a plausibility error between the signals from components Y3/8s1 (Selection range sensor (VGS)) and N15/5 (Electronic selector lever module control unit)
Operation number of operation texts and work units or standard texts and flat rates:27-0641 NOTEThe following criteria cause fault code 2805 to be stored

- Control module A80 (Intelligent servo module for DIRECT SELECT) is not correctly learned.
- Component 'Y3/8s1 (Selection range sensor (VGS))' is not calibrated.
REMEDY

- Perform teach-in process for component 'A80 (Intelligent servo module for DIRECT SELECT)'.
Press button "F2" for further tests

Control module programming

Warning!Communication with ECU required.