[2] Check component Y76y1 (Fuel injector cylinder 1).: Short circuit to ground

[2] Check component Y76y1 (Fuel injector cylinder 1).: Short circuit to ground

Test 1: Test cables

1. Test cables
Check signal line of component Y76y1 (Fuel injector cylinder 1) for short circuit to ground.
Special tools

- Test cable 266 589 01 63 00
- Socket box 129 589 00 21 00
Test procedure Y76y1 (Fuel injector cylinder 1)

- Switch off ignition.
- Disconnect the socket M at control module N3/9 (CDI control unit).
- Connect 126-pole socket box at engine wiring harness.
- Measure resistance with multimeter between socket (M.50) 50 of the 126-pole socket box tester and ground
Specified value

- Resistor infinite ohms
Question

- Is the measurement value OK?


YES
The measurement value is OK.Possible cause and remedy in the case of stored fault code

- Check lines between control unit N3/9 (CDI control unit) and component Y76y1 (Fuel injector cylinder 1) as well as connections and connectors for damage, correct fitting, loose contact and corrosion, and repair or replace as necessary.
End of test

NO
The measurement value is not OK.Further procedure

- Test cables and connections, rectify any short circuit.
End of test