AR77.37-P-1000-04R Disconnect Hydraulic Lines From Hydraulic Pump and Connect

AR77.37-P-1000-04R Disconnect Hydraulic Lines From Hydraulic Pump And Connect
- except CODE (P99) Special model "AMG Black Series"

Soft Top Hydraulic Components:

Special Tool:

The hydraulic unit RVC [UVS] (A7/5) is removed and put down in a suitable container for catching escaping hydraulic fluid.







1. Open emergency operation valve (3) on RVC [UVS] hydraulic unit (A7/5) and then tighten with specified tightening torque.

Not when separating hydraulic lines No. 115 and No. 116 on vehicles with code (881) Remote trunk closing (RTC).
By opening the emergency operation valve (3), the pressure in the hydraulic lines is relieved, except in hydraulic line No. 100. The pressure in hydraulic line No. 100 is still present. It is only possible to relieve the pressure in this line by previously setting up the roll bar hydraulically and then putting it back down mechanically.







2. Unscrew bolts (1) and slide connection plates (2) in direction of arrow.

Connect: Tighten bolts (1) with specified tightening torque.







3. Unscrew bolt (3), slide connection plate (4) in direction of arrow and remove.

On vehicles with code (881) Remote trunk closing (RTC).

Connect: Tighten bolt (3) according to specified tightening torque.

4. Pull hydraulic lines out of hydraulic unit RVC [UVS] (A7/5).
5. Plug disconnected hydraulic lines and all open connections on RVC [UVS] hydraulic unit (A7/5) with stop plugs.
6. Connect in reverse order.