AR88.50-P-5000-01R Positioning Trunk Lid To Assembly Position

AR88.50-P-5000-01R Positioning Trunk Lid To Assembly Position
(MODEL 230 except CODE (P99) Special model "AMG Black Series")






The trunk lid can be adjusted to the assembly position when the Vario roof is closed or open.







1. Open trunk lid.
2. Unclip covers above lock and unlock screws (1) from side luggage compartment lining (2).

Previously move open Vario roof to load assist position.

3. Turn lock and unlock screws (1) counterclockwise as far as the stop.

Tubular frame locks are unlocked.







4. Raise tubular frame (3) at rear with aid of helper. Support trunk lid by hand







5. Support trunk lid with a suitable object, e.g. an adjustable support brace.

Do not put trunk lid under load in wing position to prevent damaging tubular frame and trunk lid hinge.







Move trunk lid to assembly position with Vario roof switch:

6. Actuate Vario roof switch until the trunk lid is fully upright as shown in the diagram.
7. Unlock trunk lid lock and move the trunk lid to the assembly position.







8. Support trunk lid with a suitable object, e.g. an adjustable support brace.

Do not put trunk lid under load in wing position to prevent damaging tubular frame and trunk lid hinge.

9. Return trunk lid to normal position in the reverse sequence.