AR01.10-P-0010-01T Connect Compression Tester

Connect compression tester









1. Remove cover of left fuse and relay box in the engine compartment.
Installation: Check rubber seal in cover, replace if required.
Cover must be located in the groove at the rear.

2. Disconnect plug (1) at driver-side control unit with fuse and relay module (N10/1).
Shown on model 211.006





3. Plug adapter line (2) into plug position 5 of plug (1).
Shown on model 211.006





4. Connect adapter line (2) with line (3) of compression tester.
5. Connect terminal (4) of compression tester at connection (5) of driver-side SAM control unit with fuse and relay module (N10/1).
Shown on model 211.006