[8] Check component G2/5 (200A alternator with bit synchronous interface).: 8

[8] Check component G2/5 (200A alternator with bit synchronous interface).: 8

Test 1: Alternator diagnosis

1. Alternator diagnosis
Possible cause and remedy

- Check electrical line between component N3/9 (CDI control unit) and component G2 (generator) for contact and routing and (or) line breaks.
- Test wiring from component N3/9 (CDI control unit) to component G2 (generator) with an ohmmeter for short circuit (positive or negative) and repair, if necessary.
Connect test wiring harness with socket box with component N3/9 (CDI control unit) not connected.Other possible cause of fault

- The alternator regulator is defective
End of test