GF77.20-P-2012PC Close Panoramic Sliding Roof Function

GF77.20-P-2012PC Close Panoramic Sliding Roof Function

- with CODE (413) Panoramic sliding roof
- up to Model Year 8

Function requirements
- No overvoltage/undervoltage
- Circuit 15R ON or
- Circuit 15 ON and
- The overhead control panel control module (N70) recognizes the neutral position before switch is activated (no activation within 1 second)

Function
The "close panoramic sliding roof" function is only available when the panoramic sliding roof is in the normalized state.

It is deployed by moving the roof system switch (N70s1) toward the front of the vehicle. The roof system switch (N70s1) must remain manually pressed. The overhead control panel control module (N70) then actuates the roof system motor (M12m1), which closes the panoramic sliding roof. The motor operates for as long as the switch is activated or until the panoramic sliding roof reaches its end position.

The "close panoramic sliding roof" function is aborted if a lock-up of the panoramic sliding roof is detected. The panoramic sliding roof is not equipped with an obstruction sensor.