GF82.85-P-2006QJ Switch On/Off Behavior, Function
GF82.85-P-2006QJ Switch On/Off Behavior, Function
- with CODE (255) Audio 30
- with CODE (498) Japanese version
ON/Off characteristics
Activation of entire system
Actuator 0
By inserting the transmitter key (A8/1) into the electronic ignition switch control module (N73) in position 0 "terminal 15C" only the bus systems are activated for 3 min, in order to enable a faster switch-on process.
This process is initiated by the radio (A2) over the wake-up line by means of a signal. A wake-up signal can also be triggered by the telephone for example.
If the radio (A2) is switched on with the ON button (ON/OFF), automatic cutout occurs after 30 minutes.
Position 1
By turning the transmitter key (A8/1) to position 1 "terminal 15R ON" the device is switched on, insofar as it was switched on before the last removal of the transmitter key (A8/1). It remains in operation, until the transmitter key (A8/1) is removed again.
The function options are restricted to:
^ Operating the radio (A2)
^ Multifunction display (A1p13) in the instrument cluster (A1)
^ Operation of multifunction steering wheel (MFL)
Position 2
By turning the transmitter key (A8/1) in position 2 "terminal 15 ON" all functions in the vehicle are operational.
The system which was active before it was last switched off is switched on and the corresponding basic menu is displayed.
Position 3
The engine is started in position 3 of the transmitter key (A8/1) "terminal 50 ON". If a considerable voltage drop occurs while starting the engine, the system switches off for this duration but switches back on again once the on-board electrical system has stabilized.
Characteristics when pressing the ON/OFF button
The radio (A2) can also be switched on when the transmitter key (A8/1) is removed, by pressing the ON/OFF button on the rotary switch. All D2B functions are then available for 30 minutes. The system switches off automatically once this time has elapsed. Once switched off the radio (A2) can be switched on again by pressing the On/Off button. The cycle starts all over again.
On/Off characteristics via "AUTO-ON"
Due to an incoming telephone call or an SMS, telephone interface (A34/4) is activated during the run-on time and introduces a wake up pulse via the D2B.
Switching off is effected either via the ON/OFF button or by removing the transmitter key (A8/1).
An active phone call is not interrupted by removing the transmitter key (A8/1). In this case the D2B system will switch itself off.
Switch off characteristics
The radio (A2) is switched off by removing the transmitter key (A8/1) "terminal 15C OFF" from the electronic ignition switch control module (N73). It is always in standby mode when the CAN interior (CAN-B) is active.
Battery voltage below 9.5 V (undervoltage)
The radio (A2) is automatically placed into a defined standby condition. In addition to this the current operating status is stored. In this condition, the radio (A2) cannot be operated or actuated by STAR DIAGNOSIS. Communication with external components does not take place.
