AZ82.20-P-0001-01R Fit Illuminated Door Sill Molding

AZ82.20-P-0001-01R Fit Illuminated Door Sill Molding

1 Drill 6 mm dia. hole at marked point (see arrow) through bead on frame floor system (FFS) and treat with corrosion protection agent.

Do not damage carpeting in vehicle.

2 Secure connection cable for the lamp foil to the underside of the illuminated door sill molding (1) with adhesive tape (2) (see figure on left).










3 Open connector housing (5) at connection wire of illuminated door sill molding and pull out wires.
4 Route connection lead for illuminated door sill molding (1) to passenger compartment through bore hole (see arrow) and insert into connector housing (5).

Use clamps as required.

5 Clip in illuminated door sill molding (1).