AR68.20-P-2070R Remove/Install Front Floor Covering (Right)

AR68.20-P-2070R Remove/Install Front Floor Covering (Right)










Remove
1 Remove front seat on right
2 Remove side paneling (1) in right rear
3 Unscrew screw from belt buckle (2) in right rear and remove belt buckle
4 Remove stowage box (3)
5 Remove cover on center console
6 Remove cover below instrument panel (5) (on right)
7 Unhook luggage net (8) from right of mounts and remove
8 Unscrew screw and remove A-pillar paneling from right bottom
9 Separate Velcro strips (4) from floor covering (6.2) in area of dotted line
10 Cut floor covering (6.2) with sharp knife along dotted lines

CAUTION: Do not damage electric and pneumatic lines

NOTE: Cut floor covering along dotted lines to avoid time-consuming removal work for heater and air conditioning system.

11 Pull floor covering (6.2) out below instrument panel (5), lift at rear and remove from vehicle
12 Prepare floor covering (6) for installation

CAUTION: Before installing floor covering (6.2) dean passenger compartment in area of floor covering.

NOTE: When replacing floor covering (6.2) cut new floor covering (6) with sharp knife along dotted line and remove section (shaded area) below heater system.

Install
13 Install floor covering (6.2) in passenger compartment and position

NOTE: Guide cut edges in front area below instrument panel (5) (arrows), simultaneously route wiring harness (7) for passenger seat.

14 Insert A-pillar paneling at bottom right and tighten screw
15 Hook luggage net (8) at right into mounts
16 Install cover below instrument panel (5) (right)
17 Install cover on center console
18 Install stowage box (3)
19 Install belt buckle (2) in right rear
20 Install side paneling (1) in right rear
21 Install front seat on right