Procedures

AZ88.00-P-0001-02O Convert Front Bumper
- up to 28.2.06


Preparation







1. Remove Parktronic wiring harness (9).
2. Remove impact absorber (10).
3. Remove fog lamp (7) and rosette for windshield cleaning system (6).
4. Remove internal component (8) and protective strips (2).
5. Remove license plate lid (1), grille (3) and tow eye lid (4).

Assembling

6. Assemble and install bumpers in opposite order.

Use AMG license plate molding.







7.1 Only with "Safety Car" bumper
- Install cutout for right front fog lamp in right internal component (11) as shown in picture.







8.1 Only with "Safety Car" bumper
- Install cutout for left front fog lamp in right internal component (12) as shown in picture.







9.1 Only with "Safety Car" bumper
- Fasten front fog lamp (7), left and right, in bumper with bolts (13).
- Connect wiring harness (17) to front fog lamp (7), left and right.










10.1 Only with "Safety Car" bumper
- Install clips (15) in left and right side recess in bumper.
- Clip right outer grille (14) into bumper.

Left outer grille and right outer grille (14) are different.







11.1 Only with "Safety Car" bumper
- Clip left outer grille (16) into bumper.

A black cover is installed on the inside of the left outer grille (16)