Instruments - Clock Setting Procedure

Date: May 27, 2004

Order No.: P-B-82.85/363

Supersedes:

Group: 82

SUBJECT:
Model 211.026/065/070/076/082/083/265/282/283, Equipped with Navigation Switching

Between Daylight Savings and Standard Time in COMAND

For Information Only!
The time display in COMAND and the instrument cluster does not auto-correct with seasonal time changes, example: daylight savings to standard time. The time in both the IC (Instrument Cluster) and COMAND must be changed manually whenever necessary per the below procedure.

1. Press "SERV" hard key

2. Select "Time" by pressing soft-key next to the display

3. Press up and down arrows located around "OK" button to adjust time or date.

4. Press left and right arrows located around "OK" button to select hours or minutes.

5. Select "Back" by pressing soft-key next to the display to store new setting

Note:
When changing time in vehicles equipped with navigation, it is necessary to perform time adjustment with the vehicle outside to allow GPS reception.