AR18.40-P-5111PR Remove/Install Oil Level Sensor

Remove/Install Oil Level Sensor

Shown On Engine 111:

DANGER:
- Risk of death, Death may result if vehicle slips or topples from the lifting platform.
- Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.

1 Remove engine compartment paneling
2 Drain and collect engine oil

CAUTION: Installation: Replace seal of oil drain plug, in order to avoid oil leakage.

3 Unplug connector (1)
4 Unscrew screw (2)
5 Remove oil sensor (oil level, temperature and quality) (B40)

CAUTION: Installation: Replace O-ring (3) from oil sensor (oil level, temperature and quality) (B40), in order to avoid oil leakage.

6 Install in the reverse order.