GF72.29-P-3007S Automatic One-Touch Up/Down Feature, Function

GF72.29-P-3007S Automatic One-touch Up/Down Feature, Function

Function prerequisites
- Voltage not too low or too high and
- Circuit 15 ON or circuit 15R ON
- Power window synchronized
- Function not disabled, version coding

Function
The automatic one touch up/down feature is triggered by momentarily pressing the power window switch past the first catch point in direction "close" or "open". The corresponding door control module (N69/1, N69/2, N69/3 or reads in the switch state and actuates N69/4) the power window motor (M10/3, M10/4, M10/5 or until it M10/6) recognizes via the position recognition that the window is completely closed or open.

If the window is not synchronized the manual opening/closing mode is used instead of the automatic one touch up/down feature.

Function interruption
The automatic one touch up/down feature is interrupted when
- the power window switch is actuated again or
- the pinch protection is actuated as the window closes or
- the function prerequisites are no longer fulfilled.