AR68.10-P-1180M Remove/Install Molding on Instrument Panel

AR68.10-P-1180M Remove/Install Molding on Instrument Panel

















Removal, installation
1 Remove glove compartment
2 Unscrew mounting nuts (4) for molding (1)

NOTE: Molding (1) is screwed onto instrument panel (3) from rear in area of glove compartment (arrows)

3 Pry grub screws (2) on molding (1) out of insert clips on instrument panel (3) with long wedge
- See "Special Tools" below.

Installation: Replace defective insert clips on instrument panel

4 Disconnect electrical connectors on rear of molding (1)
5 Install in opposite order.

Special Tools

Long Wedge P/N # 115 589 03 59 00: