AR68.20-P-2310M Remove/Install Gearshift Lever Cover

AR68.20-P-2310M Remove/Install Gearshift Lever Cover







1 Move selector lever into position "N".
2 Remove selector lever handle.
3 Remove shift gate cover (1) with plastic wedge.

- See "Special Tool" given below.

4 Disconnect connector from rear of shift gate cover (1).

NOTE: Installation: Ensure that locking springs (3) are fastened correctly in electronic selector lever control module (N15/5)

5 Pull shift lever cover (2) at rear center uniformly off of clips (4).
6 Disconnect connectors from rear of cover on shift lever (2)
7 Remove cover from gearshift lever (2).
8 Install in the reverse order.

Special Tool

Long Wedge P/N # 115 589 03 59 00: