Rear Door Window Motor: Service and Repair

AR72.29-P-1880M Remove/Install Power Window Motor In Rear Door

1 Remove door liner from rear door
2 Partially remove insulating mat from inner door panel

NOTE: From bottom to top until inner Torx screws are visible.

3 Disconnect left/right power window motor connector (M10/5x1, M10/6x1) from left/right rear power window motor (M10/5, M10/6)
4 Unscrew Torx socket bolts (1)
- See "Special Tools" below.

CAUTION: Protect motor against falling down

- Bolt of motor of electric window lifter of rear door: 5 Nm

5 Remove left/right rear power window motor (M10/5, M10/6) from power window and door

NOTE: Before installing grease gear on motor lightly.

6 Install in the reverse order.

Special Tools

Rear Door Window Motor: Service and Repair

Special Tools: