A/T - DTC's 2200/2201/2767/2768/Limp Home Mode

Date: January 22, 2009

Order No.: S-B-27.50/59f

Supersedes: S-B-27.50/59e dated Dec. 2, 2008

Group: 27.50

Revision History

Revision Date Purpose

f 1/22/09 Revised Information (sensor ring removed as possible cause)

e 12/2/08 Warranty Information Updated

d 10/31/08 Warranty Information Updated - Op Code 27-1255 Included

c 10/17/08 Applicable Models Updated and Remedy Revised

b 1/4/08 Operation Code Updated

a 3/16/06 Warranty Information Updated

- 10/13/05 Initial issue

SUBJECT:
All Models Equipped with 7G-Tronic Trans.(NAG2)

Transmission in Limp Home Mode with Fault Codes 2200, 2201, 2767 and 2768

If you receive customer reports in the above model vehicles of the transmission being in limp home mode with fault codes 2200, 2201, 2767 and 2768, the condition is related to the speed sensor. To resolve, replace the electrohydraulic control module (valve body). Refer to WIS document AR27.19-P-0200w. Refer to EPCnet for the applicable part number, being sure to regard the footnotes carefully.

Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on January 22, 2009. Please refer to Netstar --> Star TekInfo --> Star Time for the most current labor time allowance.





In Case of Warranty, use the table.