AR83.50-P-9090M Remove/Install Rear Heater Core Temperature Sensor

AR83.50-P-9090M Remove/Install Rear Heater Core Temperature Sensor
- with CODE (582) Rear air conditioning







1 Remove rear AC control module (N22/4)
2 Remove center console (1)
3 Disconnect connector (2)
4 Pull heat exchanger temperature sensor for rear air conditioning, from the AC housing on the left (B10/9)
5 Pull heat exchanger temperature sensor for rear air conditioning from the AC housing on the right (B10/10)
6 Install in the reverse order.
7 Turn on air conditioning and idle engine for about 4 minutes.

NOTE: Set left and right temperature of rear AC control and operating module to "LO" Switch blower over to the maximum setting.

8 Check function of air conditioning.

NOTE: Air outlet temperature at the center nozzle shall not fall below + 5 degrees C, and if necessary, carry out diagnosis.