AR91.30-P-1920M Remove/Install Blower Regulator For Rear Seat Ventilation Motors

AR91.30-P-1920M Remove/Install Blower Regulator For Rear Seat Ventilation Motors
- with CODE (224c) Electrically adjustable rear single seats, with seat ventilation, seat heater and memory package
- with CODE (402a) Seat ventilation of rear seats







1 Remove rear seat backrest
- With electrically adjustable rear bench seat, code 223b.
- With rear single seats, electrically adjustable, with seat ventilation, seat heater and memory package, code 224c.

2 Place rear seat backrest (1) onto suitable clean surface with backrest upholstery (3) facing downwards.
3 Pull backrest upholstery (3) out of clip groove (see arrows) in backrest frame (2)

NOTE: Relieve strain on backrest upholstery (3) by pressing down on backrest frame (2)

4 Unscrew bolt (4) and remove left (N29/3) and right (N29/4) rear seat ventilator blower regulator

NOTE: Make bolt (4) accessible by pushing foam rubber (5) down.

5 Disconnect connector (6) from left (N29/3) and right (N29/4) rear seat ventilators
6 Install in the reverse order
7 Perform seat ventilation function test.