AN88.50-P-0002-05M Retrofit Hydraulic Pump and Work Cylinder

AN88.50-P-0002-05M Retrofit Hydraulic Pump And Work Cylinder







1. Insert RTL hydraulic pump (M51) into foam rubber bottom section (8) and insert between battery and wheelhouse.
2. Clip work cylinder (5) into lever (11) and bolts (see arrow).
3. Route hydraulic lines (12) along present reinforcement lines and fasten with cable strap.

Mask sharp edges in area of hydraulic lines (12) with felt.

4. Install upper foam rubber section (13) above RTL hydraulic pump (M51).
5. Route ventilation hose (4) as shown in figure and install on battery and in rubber grommet (10) (see magnified section).