Removal and Replacement

AR82.35-P-6980P Remove/Install Windshield Washer Hose











DANGER:
- Injury Hazard Windshield wiper mechanism can pinch, crush or, in extreme cases even sever extremities
- Always remove ignition key when working on windshield wiper mechanism

1 Open engine hood
2 Remove fender liner from front fender
3 Disconnect heated washer nozzle hose connector (X88/7)
4 Remove windshield washer hose (11)

NOTE: Hose on windshield washer fluid pump (M5/1). Close pump.

See "Special Tools" given below.

5 Unscrew screws, ventilation grille to engine hood(1)
6 Take off ventilation grille

CAUTION: Avoid damaging paintwork at hood and at ventilation grille.

7 Press T-piece (2) out of left windshield washer nozzle (4)
8 Push elbow (3) out of right windshield washer nozzle (5)
9 Open cable duct (15)
10 Open cable strap.

NOTE: All cable straps for windshield washer hose to wiring harness.

11 Expose windshield washer hose (11) and remove
12 Install in the reverse order
13 Check fluid level of windshield washer system and correct if necessary
14 Windshield wiper, windshield washing system function check


Special Tool

Set Of Plugs, P/N # 129 589 00 91 00: