AR20.40-P-5000PK Remove/Install Electric Fan

Remove/Install Electric Fan

Shown on model 203.045 with Engine 111.955, Part 1:

Shown on model 203.045 with Engine 111.955, Part 2:

1 Remove air cleaner housing
2 Remove recirculated air flap actuator

NOTE: Only for Engine 111.955

3 Remove air inlet pipe (1)
4 Detach hood cable
5 Take off dips (3) of air guide
6 Detach cable strap (4) at front end crossmember
7 Unscrew screws (5)
8 Unscrew screws (6)
9 Unscrew retaining pin (7) on right and left
10 Press together retaining clamp (8) of radiator on right and left and release the upper frame crossmember
11 Separate plug connection (9) at hood lock on right
12 Disconnect connector (10) of the electric suction fan engine and AC with integrated control (M4/7)
13 Press the clamps (11) of the electric suction fan engine and AC with integrated control (M4/7) on the right and left and at the same time take effect of the suction fan to the top
14 Take out electric suction fan engine and AC with integrated control (M4/7) from top

NOTE: Pull radiator bridge slightly forward for this step.

CAUTION: Installation: Ensure that the plates (12) of the suction fan are located in the mounts (13) of the radiator on right and left.

15 Install in the reverse order
16 Carry out operational check of hood lock
17 Inspect size of gap of hood.