AR77.20-P-1300PB Remove/Install Seal For Tilting/Sliding Roof Panel

Removing And Installing Seal For Tilting / Sliding Roof Panel







Remove
1 Remove sliding/pop-up roof cover (1)
2 Lower pop-up mechanism
3 Remove seal (2) from sliding/pop-up roof frame

Install
4 Clean gluing surfaces
5 Glue seal (2) onto sliding/pop-up roof frame

NOTE:
- Press on min 10 seconds
- The colored stripe should be on the outside of the seal (2)
- The seal joint (2) should be located on the right side in the smallest area of the gate