AR77.20-P-1410PB Remove/Install Guide Tube For Sliding/Pop-Up Roof Control Cable

Removing And Installing Guide Tube For Sliding/Pop-up Roof Control Cable





















Removing
1 Remove headliner
2 Remove sliding/pop-up roof cover
3 Remove sun blind from sliding/pop-up roof
4 Remove sliding/pop-up roof motor
5 Remove sun blind motor from sliding/pop-up roof
6 Unscrew Torx screws (1) from guide tube {27Unscrew Torx screws (3) from guide rail (4)
8 Remove guide tube (2) together with guide rails (4) through passenger door

CAUTION: Hold guide rails (4) parallel to one another, otherwise guide tube (2) can be bent.

NOTE: Rear sun blind couplings are not secured and can fall out.

9 Move slide (5) toward rear

NOTE: Until Torx screws (6) are accessible.

10 Unscrew Torx screws (6)
11 Pull guide tube (2) out of guide rails (4)

Installation
12 Slide guide tube (2) into guide rails (4)

NOTE: Position control cables correctly.

13 Screw in Torx screws (6)
14 Move slide (5) toward front against stop

CAUTION: Ensure that cover carrier (7) is positioned properly.

15 Move front sun blind coupling (8) toward rear against stop

CAUTION:
- Position assembly wedge on control cable inside as far as possible.
- Do not damage front sun blind coupling (8). Do not damage paint.

See "Special Tool" given below.

16 Move guide tube (2) together with guide rails (4) into vehicle through passenger door and align
17 Screw Torx screw (3) into guide rail (4)

CAUTION: Tighten Torx screws (1) only hand-tight.It. should be possible to move guide tube (4) to the side, however, it should make contact to the frame.

18 Screw Torx screws (1) into guide tube (2)
19 Install sun blind motor on sliding/pop-up roof
20 Install sliding/pop-up roof motor
21 Install sun blind on sliding/pop-up roof
22 Install sliding/pop-up roof cover
23 Close sliding/pop-up roof cover

NOTE: With Allen wrench on roof system drive unit (M 12).

24 Center sliding/pop-up roof cover at side

CAUTION: Outer edge of sliding/pop-up roof cover should be flush with the outer contour of the wind deflector and the rear glass roof.

25 Open and close sliding/pop-up roof cover three times.

NOTE:
- With Allen wrench on roof system drive unit(M12).
- This decreases tension and centers the guide rails (4).

26 Tighten Torx screws (3) on guide rail (4)
27 Install headliner
28 Adjusting sliding/pop-up roof cover

Special Tool

Assembly Wedge, P/N # 110 589 03 59 00: