AR77.20-P-3015PB Remove/Install Roller Sun Blind on Tilting/Sliding Roof

Remove/Install Roller Sun Blind On Tilting/Sliding Roof

















Remove

DANGER:
- Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding roof.
- When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

1 Open tilting/sliding roof

NOTE: Only when front roller sun blind is being removed

2 Remove overhead control panel control module (N70)

NOTE: Only when front roller sun blind is being removed

3.1 Open roller sun blind (1) on roller sun blind drive unit (M24) half way using Allen wrench

NOTE: Only when front roller sun blind is being removed

3.2 Open roller sun blind (1) half way with control switch on overhead control panel control module (N70)

NOTE: Only when rear roller sun blind is being removed.

4 Slightly press roller blind coupling (2) together
5 Turn roller blind end (3) upward and unhook from roller blind coupling (2)

CAUTION: Do not damage roller blind coupling (2).

6 Roll up roller sun blind (1)
7 Move roller sun blind (1) to side and remove from guide (4)

NOTE: Rear roller sun blind on passenger side, front roller sun blind on driver side.

8 Unhook roller sun blind (1) on opposite side

NOTE: Spring pretension is lost

Install
9 Clamp roller blind shaft (5) into vise on flat side (6)
10 Turn to retension spring

CAUTION: Direction of rotation: counterclockwise.

NOTE: Correct spring pretension is reached after 20 rotations.

11 Insert retaining wire (7) into opening (8)

NOTE:
- Only when installing previous roller sun blind (1)
- Use retaining wire (7) made of steel wire (0.8mm).

12 Hook flat side (6) of roller sun blind (1) into associated guide

NOTE: Retaining wire (7) must point downward.

13 Press roller sun blind (1) against stop and simultaneously pull retaining wire (7) out of opening (8).
14 Hook roller sun blind (1) into guide (4) on opposite side
15 Roll roller sun blind (1) open and remove backing paper (9)

NOTE: Only when installing new roller sun blind (1).

16 Turn in roller blind end (3) upward

NOTE: One turn

17 Hook roller blind end (3) into roller blind coupling (2).
18 Turn back roller blind end (3)

CAUTION: Do not damage roller blind coupling (2).

NOTE: Until roller blind end (3) catches audibly on both sides.

19 Install overhead control panel control module (N70)

NOTE: Only when front roller sun blind is being installed

20 Check roller sun blind (1) for proper function and fit.
21 Normalize tilting/sliding roof