AZ82.60-P-0003-01PA Retrofitting Radio Wiring Harness

AZ82.60-P-0003-01PA Retrofitting Radio Wiring Harness
- MODEL 203.0 /2 /7 for Vehicles with Radio without MB-radio


Connection schematic for radio






30 Radio wiring harness (chamber C)
A2 Radio
A2/6 CD changer (electrical preequipment)
X30/4 Right voltage distributor (CAN) connector
X30/8 Wake-up signal connector

1 Route wiring harness (30) along present leads in vehicle as shown in figure.






Connection schematic for radio

30 Radio wiring harness (chamber C)
A2 Radio
A2/6 CD changer (electrical preequipment)
X30/4 Right voltage distributor (CAN) connector
X30/8 Wake-up signal connector






2 Route tie-out for wiring harness (30) to radio (A2) and connect to chamber C.






3 Route wiring harness (30) in wiring duct in front of passenger seat as shown in figure.

A2 Radio
A2/6 CD changer (electrical preequipment)
X30/4 Voltage distributor connector (CAN)
X30/8 Wake-up signal connector (preequipment D2B interlinked components).






4 Clip wake-up signal connector (X30/8) to present connector package (see left figure section).
The wake-up signal connector (X30/8) serves only as jumper for the individual blue/black (bl/sw) leads - the connector is not connected with the standard wiring harness.

5 Install tie-out to right potential distributor connector (CAN bus) (X30/4) to next free plug location.






6 Tie tie-out from wiring harness (30) to CD player with changer (A2/6) back behind radio (electrical preequipment for CD changer).