A. Installation Preparation - All Configurations

1. Read this bulletin in its entirety before starting.

2. Unpack and compare the installation kit(s) contents against the Parts Information list as shown.

3. Place the operating guides and client accessories (i.e. chargers, cassette tapes, CDs, etc.) in the glove box or appropriate storage compartment.

Note:
If installing the telephone only, the telephone base bracket (Part Number Q 6 82 0396) must be ordered separately prior to beginning the installation.

4. Remove the trunk mat.

5. Remove the left trunk liner panel and left tail lamp assembly.

6. Remove the protective caps from the studs on the left side trunk well floor bottom.

7. Determine the number and sequence of the D2B components to be installed and then locate and configure all fiber optic cables for the configuration.

Note:
Refer to S-SI-82.64/135, D2B Fiber Optic Configuration and Version Coding for information on proper handling and configuration of D2B fibers.

8. Proceed as follows:

^ If installing the CD changer, proceed to Section B.

^ If installing only the telephone, skip to Section C.