Removal and Replacement

Removal And Installation Of Propeller Shaft Intermediate Bearing And Replacement Of Grooved Ball Bearing







1 Remove propeller shaft
2 Separate front (1, 1a) and rear propeller shaft (2) at clamp connection or slide connection

NOTE: Installation-Assemble propeller shaft

3 Pull rubber boot (4, 4a) off joint fork

NOTE: Installation: Replace damaged rubber boot and ensure correct fit.

4 Pull off rubber mount (7, 7a) with grooved ball bearing (8) and front protective cap (6)

NOTE:
- Installation: Press rubber mount with grooved ball bearing onto the joint fork
- Fit new protective cap on grooved ball bearing.


5 Remove rear protective cap (6a)

NOTE: Installation: Replace protective cap if damaged.

6 Press grooved ball bearing out of rubber mount

NOTE: Installation: Press grooved ball bearing into rubber mount.

7 Check rubber mount and grooved ball bearing for wear
- Replace parts if necessary.
8 Install in reverse sequence.